Wallee case for iPad – how to fit
Posted in General | By tim |
I bought a Wallee case for my iPad 2… Except it’s a very tight fit.
The manufacturer says this it’s tight (see below) but not impossible.
I watched the video of how to get it to fit but try as I might I could squeeze it on without putting so much pressure on the iPad I thought I might crack the glass.
In the end I put the case in hot water for a few minutes, dried it quickly and then finally did manage to get it on. I think they screwed up the design a bit but nevertheless it does fit. Don’t fancy taking it on and off regularly though.
Now got to figure out where to put it!
27 May, 2011
The Wallee for iPad 2 is a tighter fit than our case for iPad 1. This is intentional and ensures a secure fit that can be confidently mounted, at the same time allowing us to use a thinner, lighter plastic and keeping any extra thickness to a bare minimum.
Posted via email
Recent comments